SimActive Community

Hello guys,

I am currently working on an internal document for our company that highlights the steps correlator3d performs during the AT, any specifics would be greatly appreciated...

Hi Saad,

Sure, I would be happy to assist. Please find the AT steps below:

Aerial triangulation should be performed in the following order:

1. Tie Point Extraction

2. GCP Creation (if required)

3. Tie Point Editing (if required)

4. Bundle Adjustment

5. Quality Assessment

6. Image List Filtering (if required)

David, thank you very much for your assistance. I copied your (if required) comment, this was missing on my presentation.

I will keep you posted if I have any additional questions.

Thank you.

Saad