Community 3.3.6

[addisonpletcher]

Hi there,

I was wondering if there's any way to change the location of input images for a project after moving the project (Entire Correltor3D folder) to a different location. I've been able to change the folders for mosaics and DSMs in the project tree, but don't have the same option for Images. Is this a situation where I need to create a new project and reimport the images?

Thanks!

Addy Pletcher

[David Alamillo]

Hi Addy,

Sure here is a quick guide that will cover the specific workflow.

To change the image path of a project, you must go to the project folder, then to the IEO folder:
…\Correlator3D\IEO
You will find subfolders (Initial, Step_1, etc.). These subfolders contain files (Initial.ieo, Step_1.ieo, etc.) that you can open with any text editor (notepad). It will then be necessary to change the path of the images in the following section:
<RootFolders>
<RootFolder id="DIR_1">C:\path_of_images\</RootFolder>
</RootFolders>
Replace the path in the different ieo files and save the changes. You will be able to open the project and access the images again.

Best regards,

[Elena Donovan]

Thanks, very useful to know...